Cobra Jet Steering

Enhanced steering for jet skis and jet boats

  • Full Screen
  • Wide Screen
  • Narrow Screen
  • Increase font size
  • Default font size
  • Decrease font size




In most cases installation is simple and quick. Instructions can be found below.  If you have any further questions you can always email me This e-mail address is being protected from spambots. You need JavaScript enabled to view it. .
If you are installing steering units on a twin engine boat, you should always be sure that the steering nozzles are alighned evenly. I have found from experience that alighning the nozzles gets a better result. 

 Yamaha Jet Boat Install (NEW Cobra Venom ULTIMATE)



 Yamaha Jet Boat Install (NEW Cobra Venom Magnum AK Series)


Yamaha Jet Boat Install (Cobra Venom 16X MAGNUM)


Yamaha Jet Boat Install (Cobra EZ-Locks)


information about the clean out plug issues THIS WILL ANSWER A LOT OF QUESTIONS it's very informative

Mercury Optimax and V6 Jet Drive Install
Sea-Doo 4-TEC Install


General Jetski Install

Copyright © 2017 Cobra Jet Steering. All Rights Reserved. Cobra Jet Steering, Cobra EZ-Locks, and Cobra Venom 16X are registered trademarks of Cobra Jet Steering, LLC.
You are here Installation Information and Instructions